Section 5 : Installing/Removing Shipping Protection Materials - Teac P-55 Instruction Manual

SECTION 5 : Installing/Removing Shipping Protection Materials

To prevent the product from being damaged in shipment, cushioning materials and fixing metal are
used to secure the internal parts to the unit. Make sure all those protection materials are removed
before use. For the future shipment, keep the fixing metal and packing (3 types) in the packaging
box along with packing materials.
To prevent the product from being damaged in shipment, install the shipping protection materials in
reverse order to the removal procedure.
NOTE
The P-55 is a precision machine. Be careful not to drop or subject the unit to severe impact (it
weighs more than 22 kg).
This product internally reaches a high temperature when in use. Before installing the shipping
materials in the unit, leave it turned off for a while (1 hour) to cool it off completely.
Make sure the ink ribbon and transfer ribbon are removed when the shipping protection materials
are installed in the unit.
1. Peel off adhesive tape
C
.
2. Loosen the screw
F
marked to keep it for future use.
3. Peel off adhesive tape
I
cushions by pulling them toward you.
4. Pull out ribbon cartridge
for the moment. (You may want to keep the cartridge removed to load ribbons as discussed later,
in SECTION 12 : Loading Ribbons.)
5. Flip down lock lever
NOTE
Do not t ry to forcibly close the side door without flipping down the lock lever, or the side door may
be da maged.
A
from the top left of the unit and press unlock button
D
and pull out the metallic bar
G
, flip up lock lever
J
, remove cushion
H
to lock the ribbon cartridge in place and lift up the side door until it locks.
E
. Insert the removed metallic bar into position
H
to unlock the ribbon cartridge and remove two
K
and then put back the ribbon cartridge to its place
11
B
to open side door