Dial Intercom; Internal Zone Paging With Meet-Me Page - NEC Univerge SV9300 Series User Manual

DIAL INTERCOM

Dial Intercom comprises up to 10 terminals that
can call each other using a dedicated Dial Intercom
feature key with abbreviated dialing. Dial Intercom
calls can be voice announce with ringing calls.
The feature key is set by system data setting
at initial installation. For details, please
contact the system administrator.
TO INITIATE
1. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2. Press Dial Intercom feature key.
Dial Intercom feature key lamp lights green.
→
ICM
4:26 PM MON 11 MAY 2015
Recall PICK
3. Dial desired intercom terminal
number ( -
4. Press .
Change to ring tone signal.
Tone burst is sent.
TO ANSWER
1. While hearing ringing tone,
Dial Intercom feature key lamp flashes green.
→
Tone burst or ring tone is heard.
ICM
4:26 PM MON 11 MAY 2015
MIC DIR
2. Press Dial Intercom feature key.
Dial Intercom feature key lamp lights green.
→
3. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
200
>>>>
).
201
HIST. >>>>
INTERNAL ZONE PAGING
WITH MEET-ME PAGE
This feature allows terminal users to page over the
built-in speakers of the terminals within the
assigned zone or all zones.
The feature access code/feature key is set by
system data setting at initial installation. For
details, please contact the system
administrator.
TO PAGE (TERMINAL A)
The terminal A pages the terminal B.
1. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2. Dial Internal Paging access code for
desired zone or all zones or press
Internal Paging feature key assigned
for desired zone or all zones.
PAGING
4:26 PM MON 11 MAY 2015
Recall
3. Page the terminal B.
TO ANSWER (TERMINAL B)
1. Dial Meet-Me Answer access code.
They are immediately connected.
4:26 PM MON 11 MAY 2015
MIC
83
FEATURE OPERATION
PICK >>>>
200
Mute