Tascam 2488MKII Owner's Manual page 114

Appendix
No. Message
Time between IN
and OUT is too
short. Re-set
27
the points.
Press [EXIT].
Too many locate
markers. Use
DELETE MARK to
28 delete some
markers.
Press [EXIT].
Too many songs to
continue with this
operation.
29
Press [ENTER].
Too many songs.
Use SONG ERASE
to delete songs
you don't need.
30
Press [EXIT].
Too many takes.
Can't continue
recording
31
Press [EXIT].
Track already
written to disc
so only 1 song
32
can be written.
Press [EXIT].
Track is too
short. Choose
and set another
33
OUT point.
Press [EXIT].
Wrong type of
CD. Check the
disc.
34
Press [EXIT].
11
TASCAM 2488MKII
Meaning
Repeat playback or auto-punch operations
cannot be carried out because the time between
the IN and OUT locate markers is too short.
More than 999 markers have been set in the
song and so a new marker cannot be entered.
Copying a song has failed because there are
too many songs already on the selected or
target partition.
There are too many songs stored on the current
partition (the limit is 250 songs on one partition)
for a new song to be created, or a song that has
been backed up to be restored.
The repeat auto-punch procedure can't
continue because more than 99 takes have
been recorded.
Because at least one track is already present on
the disc, it is not possible to burn more than one
track at once. To burn several tracks at one time
(Disc At Once), you must start with a blank disc.
The distance between the zero point and the
OUT point is too short for mastering. A CD track
must be at least four seconds long.
The wrong type of CD for the operation has
been loaded in the drive. This could be because
: A non-writable CD has been selected for
writing An attempt has been made to finalize
an already finalized disc An attempt has been
made to erase a non- CD-RW disc. A disc
which is not a backup disc has been loaded for
a restore operation.
Action
Press NO/EXIT, and re-enter or edit the IN and
OUT points so that the time between them is
longer, before attempting the operation again.
Press NO/EXIT, and use the DELETE key
from the home screen to delete some of the
unwanted marks.
Press ENTER. Back up any songs you want
to keep, and then use the ERASE menu item
from the SONG menu to erase unwanted
songs, or songs you have backed up before
proceeding with the song copy (deleting songs
cannot be undone).
Press NO/EXIT. Back up any songs you want
to keep, and then use the ERASE menu item
from the SONG menu to erase unwanted
songs, or songs you have backed up before
proceeding with the creation or restoration of
a song (deleting songs cannot be undone).
Alternatively, use DISK -> SELECT to select
another partition.
Press NO/EXIT, stop recording, select the
desired take from the list. Press ENTER and
press AUTO PUNCH again, selecting a mode
other than LAST TAKE LOAD. Takes recorded
before this cannot be restored, so the first
selection should be made carefully!
Press NO/EXIT and replace the disc if necessary.
Press NO/EXIT, and re-set the OUT point to at
least four seconds after the zero point.
Press NO/EXIT and replace the disc with the
correct type of disc for the operation.