Fujitsu PRIMERGY RX200 S6 Service Supplement Manual page 38

Replacement routines
Figure 17: Removing a riser card - example riser card #1
Ê Remove the two screws (see circles).
Ê Remove the riser card.
Installing the new riser card
Ê Insert the new riser card.
Ê Fasten the riser card with the two screws.
Ê Install the expansion card in the PCI slot of the riser card (description see
the Options Guide).
Ê If necessary, connect the cables to the expansion card and the other
components.
Ê Position the riser card holder over the relevant slot on the system board.
Ê Carefully push the riser card holder into the slot by pressing on the green
points.
Ê Close the server and connect all power plugs (for a detailed description see
the Options Guide).
38 Service Supplement
RX200 S6