Husqvarna 430XH Operator's Manual page 26

4. Push the OK button.
3.10.4.2 To change the PIN-code
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Security > Advanced > Change PIN-code .
3. Enter the new PIN code.
4. Push the OK button.
5. Enter the new PIN code.
6. Push the OK button.
7. Make a note of the new PIN code. Refer to
Introduction on page 3 .
3.10.4.3 To create a New loop signal
The loop signal is randomly selected to create a
unique link between the product and the charging
station. In rare cases, there may be a need to
generate a new signal, for instance if two
adjacent installations have a very similar signal.
1. Place the product in the charging station.
To get access to the menu
2. Do steps 1–3 in
on page 24 .
3. Use the arrow buttons and the OK button to
move through the menu structure
Advanced > New loop signal .
4. Await confirmation that the loop signal has
been generated. This normally takes about
10 seconds.
3.10.4.4 To set duration of alarm and time lock
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Advanced > Duration .
3. Enter the time for the
the number buttons. You can select a
number between 1 to 10 minutes.
4. Use the arrow buttons to select
time lock .
5. Enter the time for the
with the number buttons. You can select a
number between 1 to 100 days. The factory
setting is 30 days.
26 - Installation
Settings >
Security >
Security >
Duration of alarm with
Duration of
Duration of time lock
3.10.5 Messages
In this menu the previous fault and information
messages can be found. For some of the
messages, there are tips and advice to help to
Troubleshooting on page
rectify the fault. Refer to
40 .
If the product is disrupted in any way, for
example it is trapped or the battery is low, a
message is saved relating to the disruption and
the time it happened.
If the same message is repeated several times,
this may indicate that an adjustment to the
installation or the product is required. Refer to
Installation on page 16 .
3.10.5.1 To read the messages
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Fault messages and Messages > Info
messages .
3. Read the messages and read the
Troubleshooting to get information and
recommendations to correct the faults.
3.10.6 Weather timer
Weather timer allows the product to
The
automatically adjust its mowing time based on
how fast the grass grows.
Weather timer is activated, the product
When the
needs time to decide the optimal mowing time for
the work area in question. For this reason it can
take a couple of days before mowing is optimized
Weather timer .
for the
The product cannot operate longer than the timer
settings. It is therefore recommended to only
deselect the times when the product must not
operate. All other time should be made available
Weather timer .
for the
Weather timer is activated, it is very
When the
important to regularly check that the blade disc is
clean and that the blades are in good condition.
Messages
1230 - 001 -