HP NetServer LC 3 Installation Road Map page 2

Installation Steps in HP NetServer LC 3 Road Map
1. Overview of HP NetServer LC 3 Features
2. Obtain HP Navigator CD-ROM Release Information
3. Set Up NetServer
4. Prepare for Hardware Installation
5. Remove the Covers
6. Install Additional Memory
7. Install All Accessory Boards
8. Install Additional Mass Storage Devices
9. Replace Covers and Connect Cables
10. Verify Installed Accessories (Optional)
11. Configure the HP NetServer
12. Install the NetServer in a Rack (Optional)
1
Overview of HP NetServer LC 3 Features
1. Unpack and verify the contents of the shipping box
against the Contents List included with your HP
NetServer LC 3.
Front Bezel
Power Switch
and Power LED
Keyboard Lock Switch
and Keyboard Lock LED
Shelf 1 (Flexible Disk Drive)
Shelf 2 (CD-ROM Drive)
Shelf 3 (Optional Mass Storage)
Hot Swap
Mass Storage
Locking Bar
Pedestal
System Board
Terminator
Board
CPU
Extractor
Handle
CPU
Front Bezel and Covers Removed
2
Obtain HP Navigator CD-ROM Release Information
To ensure that you have the latest versions of software, obtain the
current release history from one of the sources listed here. The
release history describes the latest updates to each release of the
HP Navigator CD-ROM, and tells how to obtain the current release.
Fax— Call HP's fax system at 1-800-333-1917 (or 1-208-344-
4809 from your fax machine), request document number 6005
Internet WWW
http://www.hp.com:80/netserver/support/news_main.html
Internet FTP— ftp://ftp.hp.com; logon: anonymous; password:
<your e-mail address>; cd NSNAVCD; get 6005.txt
Compuserve — Call 1-208-334-1691; download 6005.txt from
NSNAVCD library
All manuals and user guides at all-guides.com
2. If anything is missing or damaged, contact your reseller. Also,
Front Bezel Key Lock
Serial Number
Front View
Voltage Regulator Module
Retaining Latch
System Board
Backplane
(also known
as Riser
Board)
Power Supply
Module
Audience Assumptions
This road map is intended for the person who installs, administers, and
troubleshoots LAN servers. Hewlett-Packard Company assumes that you
are qualified in the servicing of computer equipment and trained in
recognizing hazards in products with hazardous energy levels.
ESD Warning
This HP NetServer contains sensitive electronic devices that can be
damaged by electrostatic discharge (ESD). ESD hazards are a result of
installation or service personnel failing to ground themselves properly. To
be properly grounded, you must use a proper ESD wrist strap and work
surface grounded to the HP NetServer chassis.
features of the HP NetServer LC 3 shown in this step.
Locked
Position
Unlocked
Position
Network
Connector
Cutout for optional
External SCSI Cable
Connector
Management Port for remote
console management using
Integrated Remote Assistant
Power
Connector
Retaining Latch
System Switches
Terminator
Board
Disk Array Controller Board
CPU (Recommended, Slot 5)
SCSI Connector
Backplane Flexible Disk Drive (FDD) Connector
Interior View
To obtain drivers and utilities for the non-HP
components of your system, follow the
directions that accompany the component or
network operating system (NOS) to access
the necessary fax, Internet, ftp, or email site
directing you to the drivers and software.
Document 6005 contains a
version number you can
compare to your CD-ROM
review the
Serial B Port
Serial A Port
Parallel Port
Mouse Port
Keyboard Port
Monitor Port
Rear View
Battery
Slot 1
Network Interface
Controller Board (Slot 6)
XXXX XXXX