Electrical Connections - JVC KD-S33 Instructions Manual

Cd receiver
Hide thumbs Also See for KD-S33:
Table of Contents

Advertisement

ELECTRICAL CONNECTIONS

Make sure to disconnect the battery's negative terminal.
• Be sure to ground this unit to the car's chassis again after installation.
Note:
It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω).
If the maximum power is less than 50 W, change "AMP GAIN" setting to prevent the speakers from being damaged (see page 14 of the INSTRUCTIONS).
Typical connections
Rear ground terminal
Line out
Antenna
terminal
To external
component
Connect only the front speakers if your
speaker system is two-speaker system.
White with black stripe
Front speaker (left)
White
Gray with black stripe
Front speaker (right)
Gray
Green with black stripe
Rear speaker (left)
Green
Purple with black stripe
Rear speaker (right)
Purple
PRECAUTIONS on power supply and speaker connections
(A) JVC CD changer, SIRIUS Satellite radio, XM Satellite radio, Apple iPod®, or JVC D. player
Set "CHANGER" for the external input setting (See page14 of the INSTRUCTIONS.)
CAUTION:
Before connecting the external components, make sure that the unit is turned off.
• For listening to the XM Satellite radio, you can also connect XMDirect
Tuner Box (separately purchased) through this unit using JVC Smart Digital Adapter—
XMDJVC100 (not supplied).
XMDirect
TM
Universal Tuner Box
Antenna (supplied
with XMDirect
TM
To CD changer, KS-PD100, or KS-PD500 if using Connection 1 (intergrated
Universal Tuner Box)
connection)
(B) JVC PnP (Plug and Play)
Set "EXT IN" for the external input setting (See page14 of the INSTRUCTIONS.)
You can also connect JVC PnP through this unit using JVC SIRIUS radio adapter, KS-U100K (not supplied).
• Turning on/off the unit can also turns on/off the JVC PnP.
CD changer jack
Install_EN_KD-S33[J]f.indd 2
Install_EN_KD-S33[J]f.indd 2
All manuals and user guides at all-guides.com
15 A fuse
Black
To metallic body or
chassis of the car
To a live terminal in the
fuse block connecting to the
Yellow *
2
car battery (bypassing the
ignition switch) (constant
12 V)
Fuse block
Red
To an accessory terminal in
the fuse block
Blue with white
To the remote lead of other
stripe
equipment or automatic antenna if
any (200 mA max.)
Connecting the external components
CD changer jack
TM
Universal
XMDJVC100
To headphones jack
Stereo mini plug
JVC PnP
DC power plug
To DC IN jack
Connecting the external amplifiers and/or subwoofer
Ignition switch
JVC Amplifier
Set "L/O MODE" to "REAR"
(See page 14 of the INSTRUCTIONS.)
JVC Amplifier
or
Set "L/O MODE" to "WOOFER"
(See page 14 of the INSTRUCTIONS.)
JVC Amplifier
Subwoofer
• For listening to the SIRIUS Satellite radio, connect a JVC DLP—Down Link Processor (separately purchased) to this unit.
• The iPod
or D. player (separately purchased) can be connected using an interface adapter (not supplied)—KS-PD100
*
5
(for iPod) or KS-PD500 (for D. player).
Connection 1 (integrated connection)
JVC DLP
or
*
*
(C) Other external component
You can also connect an external component through this unit using Line Input Adapter, KS-U57 (not supplied) or AUX Input Adapter,
KS-U58 (not supplied).
CD changer jack
2
High
Heat sink
Remote lead
Remote lead (blue with white stripe)
To the remote lead of other equipment
or automatic antenna if any
Rear speakers
Front speakers
1
*
Not supplied for this unit.
*
2
Before checking the operation of this unit prior to
installation, this lead must be connected, otherwise power
cannot be turned on.
*
3
Firmly attach the ground wire to the metallic body or to the
chassis of the car—to the place uncoated with paint (if
coated with paint, remove the paint before attaching the
wire). Failure to do so may cause damage to the unit.
*
4
Signal cord (not supplied for this unit).
Connection 2 (alternative connection)
Apple iPod
or
JVC D. player
or
JVC CD changer
iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.
5
6
Signal cord supplied with your JVC CD changer or DLP.
Signal cord (not supplied for this unit)
External
component
3.5 mm stereo mini plug
Y-connector *
1
Front speakers
JVC Amplifier
Front
speakers
JVC DLP
or
JVC CD changer
or
Apple iPod
or
JVC D. player
External
component
7/3/06 9:48:57 AM
7/3/06 9:48:57 AM

Advertisement

Table of Contents
loading

Table of Contents