JVC KD-APD58 Instructions Manual page 114

ELECTRICAL CONNECTIONS
A
Typical connections
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
Antenna connector
iPod jack (see diagram )
Line out (see diagram
White with black stripe White
Left speaker (front)
B
Connecting the external amplifier or subwoofer
You can connect amplifier to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
Set "L/O MODE" to
"REAR" (See page 14 of the
INSTRUCTIONS.)
Rear speakers
Set "L/O MODE" to
"WOOFER" (See page 14
of the INSTRUCTIONS.)
Subwoofer
C
Connecting an Apple iPod
You can connect an iPod to this unit using the supplied connection cable for iPod.
Fasten the connection cable for iPod tightly across the loop using the supplied cable tie to hold the connection
cable in place.
iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.
* 1
Not supplied for this unit.
*
2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power
cannot be turned on.
Install1_KD-PDR54_002A_f.indd 2 Install1_KD-PDR54_002A_f.indd 2
All manuals and user guides at all-guides.com
Loop (see diagram )
Rear ground terminal
15 A fuse
Black
)
* 2
Yellow
Red
Blue
Blue with white stripe
Orange with white stripe
Gray with black stripe Gray
Right speaker (front)
JVC Amplifier
or
JVC Amplifier
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
To car light control switch
Green with black stripe Green
Left speaker (rear)
Apple iPod (separately purchased)
Connection cable for iPod (supplied)
* 3
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint
(if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
*
4 Remote lead
*
5 Signal cord (not supplied for this unit).
2
Ignition switch
Fuse block
Purple with black stripe Purple
Right speaker (rear)
Y-connector (not supplied for this unit)
Remote lead (blue with white stripe)
To the remote lead of other
equipment or automatic
antenna if any
Front speakers
Cable tie
Loop
11/29/06 4:03:20 PM 11/29/06 4:03:20 PM