Table of Contents
Advertisement
Make sure vacuum cleaner is turned off and power cord is unplugged.
Problem
Motor will not start.
Vacuum does not clean
carpet or bare floor.
No suction at the
end of hose.
Turbo nozzle will not turn
(on some models).
Vacuum is hard to push.
Burning smell; brush roll
will not turn.
Thermal cut-off
This vacuum cleaner has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum
suddenly shuts off, push the power switch to off and unplug the vacuum. Check the vacuum for a possible source of
overheating such as a full dust cup, blocked hose or clogged filter. If these conditions are found, fix them and wait at least
30 minutes before attempting to use the vacuum. After the 30 minute period, plug the vacuum back in and turn on the
switch. If the vacuum still does not work, take it to a Eureka authorized service center for repair or call 1-800-282-2886.
6
Eureka Customer Service HELPLINE 1-800-282-2886
All manuals and user guides at all-guides.com
Problem solving
Cause
Power plug
Power switch
Thermal cut-off
Dust cup and filter
Belt
Hose
Dust cup and filter
Hose
Rotating brush
Belt
Belt
• Push plug securely into outlet, try another outlet or
check circuit breaker.
• Step on power switch to turn vacuum on.
• See detailed instructions below.
• Empty dust cup, clean and/or change filter.
• Clean or replace filters regularly to maintain suction. Page 2
• If picking up fine dust, the dust cup may not look full, but a
fine substance tends to reduce suction when it blocks air
flow through the filter and screen. Refer to page 2 for filter
maintenance. Make sure filter, screen and dust cup are
installed properly.
• Replace a worn, cut or out of shape belt. Page 4
• Remove clogs from the hose that restrict the airflow. Page 4
• Empty dust cup, clean and/or change filter.
• Clean or replace filters regularly to maintain suction. Page 2
• If picking up fine dust, the dust cup may not look full, but a
fine substance tends to reduce suction when it blocks air
flow through the filter and screen. Refer to page 2 for filter
maintenance. Make sure filter, screen and dust cup are
installed properly.
• Remove clogs from the hose that restrict the airflow. Page 4
• Check turbo nozzle for debris. Page 5
• Replace a worn, cut or out of shape belt.
• Check brush roll for debris. Page 4
• Replace broken or out of shape belt. Page 4
Solution
www.eureka.com
Advertisement
Table of Contents
