Cisco 1120 Installation Manual page 6

Connected grid router

Hide thumbs Also See for 1120:

Installation Safety and Site Preparation

Required Tools and Equipment for Installation and Maintenance



Number 2 Phillips screwdriver



Phillips screwdrivers: small, 3/16-in. (4 to 5 mm) and medium, 1/4-in. (6 to 7 mm)



Screws that fit your rack

In addition, depending on the type of modules you plan to use, you might need the following equipment to connect a

port to an external network:



Cables for connection to the WAN and LAN ports (dependent on configuration).



Ethernet hub or PC with a network interface card for connection to an Ethernet (LAN) port.



Console terminal (an ASCII terminal or a PC running HyperTerminal or similar terminal emulation software) configured

for 9600 baud, 8 data bits, 1 stop bit, no flow control, and no parity.



Modem for connection to the auxiliary port for remote administrative access (optional).

Table of Contents