Settings - Festool CTL Series Original Operating Manual

► Insert the filter/disposal bag [2].
► Attach the cord holder [3].
► Connect the suction hose [4].
6.2 Connecting the mobile dust extractor
WARNING
Risk of injury from tools starting up unex-
pectedly
► Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con­
nected tool is switched off.
The switch [1-8] serves as an on/off switch.
Switch position "0"
Appliance socket [1-3] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-3] is connected to the pow­
er, the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-3] is connected to the pow­
er, the mobile dust extractor starts when the
connected tool is switched on.
► Insert the plug into an earthed socket.
Pull the plug from the socket when the
machine is not in use and prior to main­
tenance and cleaning work.
6.3 Connecting electric power tools
WARNING
Risk of injury
► Observe the maximum appliance socket
connected load (see chapter "Technical da­
ta")
► Switch off the electric power tool.
► Connect the electric power tool to the appli­
ance socket [1-3].
Special features of CTL26 E SD
CTL 26 E SD E/A: Socket module with auto­
–
matic switch-on function for the use of two
electric power tools: e.g. 2 sanders, 1 jig­
saw + 1 sander
CTL 26 E SD: Socket module with perma­
–
nent power supply for use as extension ca­
ble: e.g. charger, lamp, etc.
14
6.4 Connecting pneumatic tools
WARNING
Risk of injury
► Switch off the air tool.
Automatic on/off switch for air tools (CTL
36/48 E LE, CTL 36/48 E LE AC or accessories)
with compressed air module in module slot
[1-2]
Recommendation:
– Attachment of service unit VE (495886):
compressed air filtered and lubricated
– Use of IAS system with IAS connector
(454757) for Festool air tools
Requirement: tool with operating pressure of
6 bar!
6.5 Special features of the CTL 36 E AC-
LHS
To use the mobile dust extractor in combination
with the PLANEX:
► Use kink-resistant suction hose D 36 mm x
3.5 m-AS.
► Use a special suction sleeve for connecting
the PLANEX.
► Use closing slide CT-VS between the intake
opening [1-1] and suction hose.
► Attach the tool holder.
► Always use with a disposal bag!

7 Settings

7.1 Adjusting the suction power
► Use the rotary knob [1-9].
7.2 Temperature cut-out
A temperature cut-out switches the mobile dust
extractor off when it reaches a critical tempera­
ture to prevent overheating.
► Switch off the mobile dust extractor, allow
to cool for about 5 minutes then switch on
again.
Not possible to switch on: contact
Festool service workshop.
7.3 AUTOClean - Cleaning the main filter
(only versions with AutoClean)
Only in conjunction with disposal bag
(compliance with dust class 'L'). Not suit­
able for wet extraction!
English