C Set Up For Use; Channel Set Up For The First Time - Sylvania D6313CB Owner's Manual

You can program the tuner to scan all the channels you receive in your area.
NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just
select the TV/VCR channel selector to the output channel of the cable box or satellite box (Ex CH3). Then
select the channel to be viewed on the Cable Box or Satellite Box.
CHANNEL SET UP FOR THE
FIRST TIME
1
Plug in the TV/VCR power cord
Attach the smaller end of the sup-
plied AC cord to the AC 120V
connector on the back of the
TV/VCR. Then, plug the other
end into a standard AC outlet.
NOTE:
•
You must disconnect the car battery cord from the
TV/VCR before you use AC power.
•
If some digits appear in the corner of the screen,
press the POWER button without unplugging the
power cord.
2
Turn on the TV/VCR
Press the POWER button to turn on the TV/VCR
3
Select "ENGLISH" or "ESPAÑOL"
Select "ENGLISH" or
"ESPAÑOL"=Spanish using the
F.FWD/B or REW/s button. "[ ]"
indicate the selected language.
SET UP FOR USE
4
Press the PLAY/K or STOP/L but-
ton to point to "AUTO PRESET".
Then press the F.FWD/B button.
The tuner scans and memorizes all
active channels in your area.
NOTES:
•
The TV/VCR distinguishes between standard TV
channels and cable channels.
•
If you want to play or record a video tape
BEFORE presetting the tuner, you must press the
MENU button on the remote control. To preset the
tuner again, see "CHANNEL SET UP AGAIN" on
page 13.
•
The TV/VCR may recognize TV channels to be
CATV channels by the receiving conditions. In this
case, try auto preset again in the fine receiving
conditions.
5
The tuner stops on the lowest memorized channel.
– SET UP –
If you want to recall the selected channels, you can
B LANGUAGE select the desired channel directly with the remote
[ENGLISH] ESPAÑOL
control number buttons or CHANNEL K or L button.
AUTO PRESET
TO SELECT A DESIRED CHANNEL
You can select the desires channel by using the
CHANNEL K or L button or directly pressing the
number buttons on the remote control.
Note for using the number buttons:
•
When selecting cable channels which are higher
than 99, press the +100 button first, then, press the
last two digts. (Example: to select channel 125,
first press the +100 button then press "2" and "5").
•
You must proceed single-digit channel numbers
with a zero (Example: 02 ... 09).
- 11 -
Begin auto preset
After scanning
– SET UP –
LANGUAGE
[ENGLISH] ESPAÑOL
B AUTO PRESET
EN
0B19