C Preparation For Use; Antenna/Cable Connection - Sylvania 6719DF Owner's Manual

Plug the incoming cable into the ANT. jack on the rear of the unit.
If your cable service supplies you with a converter box or if you use a
satellite system, connect the box with this unit as shown below.
Cable Antenna
or
TV signal
Incoming cable from home Antenna /
Cable Company (No Cable Box)
OR
Incoming cable from Cable Company
or Satellite Antenna
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding
system of the building as close to the point of cable entry as practical.
NOTE:
•
Before plugging the antenna into the ANT. jack of the unit, check that the pin is
not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the
ANT. jack of the unit.
NOTE:
•
For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT. jack
before moving the unit.
PREPARATION FOR USE

ANTENNA/CABLE CONNECTION

Cable Box or
Satellite Box*
ANT.
*NOTE (DO NOT DISCONNECT FROM BOX)
Some cable TV systems use scrambled signals and
require a special converter to receive these channels.
Consult your local cable company.
- 12 -
AUDIO OUT
COAXIAL
Rear of the unit
ANT.
[Fig. 4]
Bent pin
Cable
Plug
(Needs to be (Straight pin)
straightened)
EN