Download Print this page

Detecto 6500 Operating Instructions

Low-profile portable, wheelchair scale
Hide thumbs Also See for 6500:

Advertisement

Quick Links

This scale weighs approximately 40 pounds. Damage to the Load
Caution!
Cells can occur if scale is dropped or allowed to fall from the
transport position. If damage to scale is determined to have been caused by falling or
dropping scale, the warranty will be voided!
Lowering Scale from
Transport Position to Floor
1. From transport position, stand close to scale with your feet 8 to
12 inches apart.
2. Firmly grasp handles on scale.
3. While stepping back, lower scale to floor, keeping your back
straight and bending your knees until you're in a squatting
position.
Never bend at the waist with your legs straight!
DO NOT DROP SCALE!
Lifting Scale from Floor to
Transport Position
1. Stand close to scale with your feet 8 to 12 inches apart.
2. Keeping your back straight, bend your knees until you're in a
squatting position.
Never bend at the waist with your legs straight!
3. Firmly grasp handles on scale and lift straight up. Don't twist to
either side. Keep scale close to you, not at arm's length.
4. Use your leg muscles as you lift. Keep your back upright and in
its natural posture. Lift steadily and smoothly without jerking.
For storage, lay scale flat for maximum protection against damage.
Model 6500
Low-Profile Portable
Wheelchair Scale

Operating Instructions

Advertisement

loading

Summary of Contents for Detecto 6500

  • Page 1: Operating Instructions

    Model 6500 Low-Profile Portable Wheelchair Scale Operating Instructions This scale weighs approximately 40 pounds. Damage to the Load Caution! Cells can occur if scale is dropped or allowed to fall from the transport position. If damage to scale is determined to have been caused by falling or...
  • Page 2 Model 6500 Low-Profile Portable Wheelchair Scale Operating Instructions Scale Preparation Install six (6) “C” size batteries or if ordered with scale, plug the small connector end of the AC power adapter cord into the power jack located on the back of the MV1 and then plug the AC power adapter into the proper electrical outlet.