Table of Contents
Advertisement
If the TV/DVD does not perform properly when operated as instructed in this Owner's Manual, check the
TV/DVD, consulting the following checklist.
Problem
No power
The TV/DVD does not respond to
the remote control.
TV Mode
Problem
No Picture or Sound
Bars On Screen
Picture Distorted or Blurred
Picture Rolls Vertically
Lines or Streaks in Picture
No Color
Poor Reception on Some Channels
Ghosts in Picture
Weak Picture
Sound OK, Picture Poor
Picture OK, Sound Poor
Different color marks on screen
TROUBLESHOOTING GUIDE
•
Make sure the power plug is connected to an AC outlet.
•
Make sure the power is turned on.
•
Check if the power plug is connected to an AC outlet.
•
Check the batteries in the remote control.
•
Aim the remote control directly at the remote sensor. If necessary,
remove all the obstacles between the sensor and the remote.
•
You have to be within 23 feet of the TV/DVD.
•
Check if the correct mode is selected. If not switch the mode by
pressing SELECT on the remote control,whichever you need.
•
Try a new channel, if OK, then possible station trouble.
•
Make sure the power is turned on.
•
Press SELECT on the remote control to select TV mode. Then try
other TV feature.
•
Is antenna or cable connected to terminal on the back of the set?
•
If outside antenna is being used, check for broken wire.
•
If outside antenna is being used, check for broken wire.
•
Check for local interference
•
Check incoming CATV cable for loose or bad connections.
•
Try a new channel, if OK, then possible station trouble.
•
If outside antenna is being used, check for broken wire.
•
Check incoming CATV cable for loose or bad connections.
•
Try a new channel, if OK, then possible station trouble.
•
If outside antenna is being used, check for broken wire.
•
Check for local interference.
•
Check incoming CATV cable for loose or bad connections.
•
Try a new channel, if OK, then possible station trouble.
•
Is antenna or cable connected to terminal on the back of the set?
•
If outside antenna is being used, check for broken wire.
•
Adjust COLOR control.
•
Check incoming CATV cable for loose or bad connections.
•
Try a new channel, if OK, then possible station trouble.
•
Is antenna or cable connected to terminal on the back of the set?
•
If outside antenna is being used, check for broken wire.
•
Check for local interference.
•
Check incoming CATV cable for loose or bad connections.
•
Try a new channel, if OK, then possible station trouble.
•
Is antenna or cable connected to terminal on the back of the set?
•
If outside antenna is being used, check for broken wire.
•
Adjust CONTRAST & BRIGHT control.
•
Check incoming CATV cable for loose or bad connections.
•
Try a new channel, if OK, then possible station trouble.
•
Is antenna or cable connected to terminal on the back of the set?
•
If outside antenna is being used, check for broken wire.
•
Check for local interference.
•
Adjust CONTRAST & BRIGHT control.
•
Try a new channel, if OK, then possible station trouble.
•
Check for local interference.
•
Magnetism from nearby unsealeded speakers or appliances might
affect the color of the TV picture. Move the TV/DVD away from the
speakers or appliances. The TV/DVD can repair itself automatically
by unplugging the TV/DVD power cord, and then plug it in again 30
minutes or so later.
Corrective Action
Corrective Action
– 30 –
EN
0C28
Advertisement
Table of Contents
