Firmware Upgrade Parameters - Cisco 8800 Series Manual

Firmware Upgrade Parameters

Parameter Name
Log Failure Msg
User Configurable Resync
Firmware Upgrade Parameters
The following table defines the function and usage of each parameter in the Firmware Upgrade section of
the Provisioning tab.
Parameter Name
Upgrade Enable
Upgrade Error Retry Delay
Upgrade Rule
Log Upgrade Request Msg
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
72
Description and Default Value
The syslog message that is issued after a failed resync
attempt.
The default value is $PN $MAC -- Resync
failed: $ERR.
Allows a user to resync the phone from the IP phone
screen.
The default value is Yes.
Description and Default Value
Enables firmware upgrade operations independently of resync actions.
The default value is Yes.
The upgrade retry interval (in seconds) applied in case of upgrade failure.
The device has a firmware upgrade error timer that activates after a
failed firmware upgrade attempt. The timer is initialized with the value
in this parameter. The next firmware upgrade attempt occurs when this
timer counts down to zero.
The default value is 3600 seconds.
A firmware upgrade script that defines upgrade conditions and associated
firmware URLs. It uses the same syntax as Profile Rule.
Use the following format to enter the upgrade rule:
<tftp|http|https>://<ip address><:port>/<path>/<load name>
For example:
tftp://192.168.1.5/firmware/sip88xx.11-0-0MPP-321.loads
If no protocol is specified, TFTP is assumed. If no server-name is
specified, the host that requests the URL is used as the server name. If
no port is specified, the default port is used (69 for TFTP, 80 for HTTP,
or 443 for HTTPS).
The default value is blank.
Syslog message issued at the start of a firmware upgrade attempt.
Default: $PN $MAC -- Requesting upgrade
$SCHEME://$SERVIP:$PORT$PATH
Cisco IP Phone Provisioning