Configuring None Authentication For Telnet Login - HP A-F1000-E Getting Started Manual

scheme—Requires username and password authentication at the next login through Telnet.
•
Authentication falls into local authentication and remote authentication. To use local authentication,
configure a local user and related parameters. To use remote authentication, configure the username
and password on the remote authentication server. Keep your username and password.
The following table lists Telnet login configurations for different authentication modes.
Authentication
mode
None
Password
Scheme

Configuring none authentication for Telnet login

Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For information about logging in to the device with the default configuration,
see "Configuration
Configuration procedure
Follow these steps to configure none authentication for Telnet login:
To do...
Enter system view
Enable Telnet
Enter one or multiple VTY user
interface views
Configuration
Configure not to authenticate users
Configure to authenticate users by using the local password
Set the local password
Configure the authentication scheme
Remote AAA
authentication
Select an
authenticatio
n scheme
Local
authentication
requirements."
Use the command...
system-view
telnet server enable
user-interface vty first-number
[ last-number ]
Configure a
RADIUS/HWTACACS
scheme
Configure the AAA scheme
used by the domain
Configure the username and
password on the AAA server
Configure the authentication
username and password
Configure the AAA scheme
used by the domain as local
22
Remarks
For more information,
see "Configuring none
authentication for Telnet
login."
For more information,
see "Configuring
password
authentication for Telnet
login."
For more information,
see "Configuring
scheme authentication
for Telnet login."
Remarks
—
Required
Disabled by default
—