Troubleshooting - Silhouette DWC047D1BSSPR Owner's Use And Care Manual

Troubleshooting

Occasionally, a problem is minor and a service call may not be necessary- use this troubleshooting
guide for a possible solution. If the unit continues to operate improperly, call an authorized service
depot or our Toll Free Number 1-844-455-6097 for assistance.
PROBLEM
No power
Cabinet temperature
is too high
Alarm beeping and
"HI" is displayed on
the control panel
Alarm beeping and
"LO" is displayed in
the control panel
Condensation on the
cabinet and/or doors
POSSIBLE CAUSE
• A fuse in your home may be
blown or the circuit breaker
tripped
• Power surge
• Plug not fully inserted into
wall outlet
• Temperature is set too high
• Door is not shut properly or
opened excessively
• Exhaust vent is obstructed
• Recently added a large
quantity of warm beverages
to the cabinet
• Recently added a large
quantity of warm bottles or
cans to the cabinet
• The door is not closed tightly
• System leak, evaporator fan
failure or compressor fan
failure
• Sensor failure, evaporator
temperature is too low
• High humidity conditions in
the home
• Door not shut properly or
opened excessively
• Replace fuse or reset circuit breaker
• Unplug the beverage centre, wait a
few seconds and then plug it back in
• Make sure the 3-prong plug is fully
inserted into the outlet
• Verify the temperature control setting,
adjust if neccessary
• Ensure that the door is fully closed
and that the gasket is sealing against
the cabinet. Open the doors only as
needed and for short periods of time
• Verify there is nothing blocking the
front mounted exhausting vent
• Limit the quantity of warm beverages
being introduced to the cabinet at the
same time. Attempt to stagger the
load introduction if possible
• Limit the quantity of warm items be-
ing introduced to the cabinet
• Be sure the door is closed tightly
• Contact a service centre, to stop the
beeping, unplug the unit
• Contact a service centre, to stop the
beeping, unplug the unit
• The condensation will subside once
humidity conditions return to normal
• Ensure that the door is fully closed
and that the gasket is sealing against
the cabinet. Open the door only as
needed and for short periods of time
12
SOLUTIONS