Specifications - Banner QM26 Series Instruction Manual

Specifications

Supply Voltage and Current
10 to 30 V dc (10% maximum ripple within specified limits); supply current
(exclusive of load current) < 20 mA
Note: For UL applications: For use in class 2 circuits
only.
Supply Protection Circuitry
Protected against reverse polarity and transient voltages
Output Configuration
XLPC models: Single PNP or NPN on pin 4 (black wire) with remote input on pin
2 (white wire)
All other models: Complementary PNP or NPN by model number
Delay Before Power-Up
< 300 ms
Output Rating
100 mA per output
Off-state leakage current for load = 1500 Ω:
NPN: < 200 μA
PNP: < 500 μA
ON-state saturation voltage: < 2 V at 100 mA
Output Protection Circuitry
Protected against false pulse at power up, and overload or short circuit of
outputs
Emitter LED Wavelength
AF200 models: 660 nm
All other models: 620 nm
Required Overcurrent Protection
WARNING: Electrical connections must be made
by qualified personnel in accordance with local
and national electrical codes and regulations.
Overcurrent protection is required to be provided by end product application
per the supplied table.
Overcurrent protection may be provided with external fusing or via Current
Limiting, Class 2 Power Supply.
Supply wiring leads < 24 AWG shall not be spliced.
For additional product support, go to www.bannerengineering.com.
Supply Wiring (AWG)
20
22
24
26
28
30
8
Required Overcurrent Protection (Amps)
5.0
3.0
2.0
1.0
0.8
0.5
www.bannerengineering.com - Tel: +1-763-544-3164
Output Response Time
500 µs
Repeatability
QM26—Opposed Models: 110 μs
All other models: 150 μs
Indicators
Green on: Power ON and sensor ready
Yellow on: Light sensed
XLPC models—Yellow flashing: Light sensed but marginal signal
Construction
Housing: 316L stainless steel
Optical Window: Coated acrylic (PMMA)
Indicator and buttons: TPV - PE
Connection
4-wire 5 m (16.25 ft) cable or 4-pin M12 Euro-style quick disconnect connector
with 200 mm (7.5 in) PVC pigtail, depending on model
Banner recommends using the 4-Pin Threaded M12/Euro-Style Cordsets—
Washdown, Stainless Steel cordsets listed in the Accessories section.
Note: These proximity switches shall be used with
UL Listed Cable assemblies rated 30 V, 0.24 A
minimum, in the field installation.
Adjustments
QM26 Emitter—Beam Enable: Connect black wire to +V dc to activate emitter
LED
AFxxx models—Adjustment Screw: Sets background suppression distance
XLPC models—Push Button: User set up
XLPC models—Remote Input Wire: Remote PLC set up and push button lock
out
Environmental Rating
IEC IP67 and IEC IP69K
Chemical Compatibility
®
ECOLAB certified
Operating Conditions
Operating Temperature and Storage Temperature: –30 °C to +70 °C (–22 °F to
+158 °F)
Note: UL certified in the temperature range –30 °C
to +55 °C (–22 °F to +131 °F).
Humidity: Periodic exposure to 100% humidity and washdown cleaning
Vibration and Shock
IEC60947-5-2
Certifications
with class 2 power supply
QM26 and QMH26 Series Sensors
P/N 166534 Rev. E