Frc·4 Dtmf Pageror Dvs-3 Digita/ Voice Recorder!Dtmf Pager Lnstallation - Yaesu FT-5200 Manual

This section descnbes the installation procedures for
the DVS-3 Dtgital Voice Recorder/DTMF Pager, FRC-4
DTivfF Pager, FTS-22 Tane Squelch Unit and the YSK-
1/11 Trunk Mounting K1ts. These options are avatlable
from your Yaesu dealer Ifl11stall.mg both the FrS-22 and
either the FRC-4 or DVS-3, instail the FTS-22last.
Note!
The FRC-4 and DVS-3 cannot be installed togeth-
er. The DVS-3 includes allfuncuons ofthe FRC-4.
FRC-4 DTMF Pager or DVS-3 Digitai
V o ice Recorder!DTMF Pager Installation
The FRC-4 provides DTMF paging/selcall features
using 3-digit DTMF stati an ID code s. S ix code memories
stare your ID code plus those of five frequently-called
stations. Contro! is provided through the front pane! of
the transceiver. The DVS-3 inc!udes ali features cf the
FRC-4, plus recording and playback of received signals
and messages for rransrnission. See the "Operation"
chapter far operational details.
The FRC-4 and DVS-3 install in the same location,
and cannot both be installed together. I falso installing the
FTS-22 Tane Squelch Umt, sa ve tt until after the FRC-4
or DVS-3 is installed.
O Disconnect the DC power cable, and set the transceiv-
er upside-down. Refening to Ftgure l, remove the six
screws affuing the bottom cover, and remove the
cover.
O Lllt the speaker out of its bracket, and set the bracket
and speaker aside for now. Referring to Figure 2, note
the accessory mounting location. If the FTS-22 is
alre ad y installed, you will need to remove i t temporar-
lly: just lift the FTS-22 board gently, allowing the
double-sided tape undemeath to come urutuck. Keep
the tape 'Nith the FrS-22 board, and fold it aside for
the moment (there
LS
no need to disconnect it).
O
If
the FRC-4 is installed and you are installing a
DVS-3 (or vice-versa), remove the screw holding the
installed board, and unplug
itS
three cables.
O Referto Figure 3 for the Iocation of the three connec-
tors used bytheFRC-4 andDVS-3 Gustm frontofthe
loudspeaker's pos1tion). CoMect the cables from the
FRC-4 or DVS-3 to these connectors carefully, so as
not to install the plugs upside down.
O Position the FRC-4 or DVS-3 as shown in Figure 4,
and use the supplied sete w to fix it in piace.
O Ifthe FTS-22 was already installed, reuse thedouble-
sided tape to stick it on top of the newly installed
board, in the same ;vay it was installed before (that is,
wlth the cable ruMi.ng aver the top of the FTS-22).
O If mstalling an FrS-22
in
this transceiver far the
fJISt
tirne, proceed to the FTS-22 procedure below. Other-
'Nise, replace the loudspeaker and its bracket, the top
cover, and its s.ix screws.