KX-TG2323AGB / KX-TGA231AGB
11.1. Check Power
BASE UNIT
Cross Reference:
Power Supply Circuit (P.56)
Reset Circuit (P.58)
11.2. Error Message Table
Display
E1
The initialization was tried, but it could not be done.
E3
When the adjustment data was checked, an error was
E9
detected. (The adjustment data may not be written.)
Note:
Flash Memory is IC701.
Symptom
28
Note:
DSP is IC501.
1. Check the peripheral circuit of Flash Memory visually.
2. Confirm that the voltage is added to the power supply pin.
If no voltage is detected, replace the Flash Memory because it
might be defect.
3. Solder the Flash Memory again.
Remedy