Replacing The Flat Tire; Storing The Flat Tire - Honda ODYSSEY 2020 Owner's Manual

HANDLING THE UNEXPECTED

Replacing the Flat Tire

n
1. Remove the wheel nuts and flat tire.
2. Wipe the mounting surfaces of the
wheel with a clean cloth. Mount the
compact spare tire. Screw the
wheel nuts until they touch the lips
around the mounting holes, then
stop rotating.
3. Lower the vehicle and remove the
jack. Tighten the wheel nuts in the
order indicated in the image. Go
around, tightening the nuts, two to
three times in this order.
Wheel nut torque: 94 lbf-ft (127 N-m,
13.0 kgf-m)
Do not over tighten the wheel nuts
by applying extra torque using your
foot or a pipe.
If you drive with the spare tire installed, the low tire pressure/TPMS
indicator appears. The indicator stays on until a regular tire is installed and
the TPMS system is recalibrated.
174 |

Storing the Flat Tire

n
1. The storage bag, bracket, mounting
wing bolt (A) and mounting wing
bolt (B) are in the tool case.
2. Put the flat tire in the storage bag
provided with your vehicle.
3. On the driver's side of the third row seat, pull down the U-shaped carpet
piece and use a coin to remove the plastic screw. Install the bracket and
the mounting wing bolt (A) on the attachment point and tighten the bolt.
Install the flat tire on the bracket with the inside of the wheel facing
toward you.
HANDLING THE UNEXPECTED
| 175