To Extend The Boundary Wire Or The Guide Wire; After The Installation Of The Product; To Do The Product Settings - Husqvarna Automower 105 Operator's Manual

3.7 To extend the boundary wire or the
guide wire
Note: Extend the boundary wire or the guide wire
if it is too short for the work area. Use original
spare parts, for example couplers.
1. Cut the boundary wire or the guide wire with
a pair of wire cutters where it is necessary to
install the extension.
2. Add wire where it is necessary to install the
extension.
3. Put the boundary wire or the guide wire into
position.
4. Put the wire ends into a coupler.
Note: Make sure that you can see the ends
of the boundary wire or the guide wire
through the transparent area of the coupler.
5. Push the button on the coupler with an
adjustable pliers.
6. Put the boundary wire or the guide wire into
position with stakes.

3.8 After the installation of the product

3.8.1 To do a visual check of the charging
station
1. Make sure that the indicator LED lamp on
the charging station has a green light.
2. If the indicator LED lamp does not have a
green light, do a check of the installation.
Indicator lamp in the charging
Refer to
station on page 36 and To install the
charging station on page 18 .
20 - Installation
3.8.2 To do the basic settings
Before you start the product for the first time, you
must do the basic settings and calibrate the
product.
1. Push the STOP button.
2. Set the Main switch to
3. Push the multi-choice buttons. Select
language, country, date, time and set a PIN
code.
Note: It is not possible to use 0000 as PIN
code.
4. Put the product in the charging station.
5. Push the START button and close the hatch.
The product then moves away from the charging
station and stops, while it calibrates some of the
product settings.

3.9 To do the product settings

The product has factory settings but the settings
can be adapted to each work area.
3.9.1 To get access to the menu
1. Push the STOP button.
2. Enter the PIN code on the keypad.
3. Push the MENU button.
3.9.2 To do the timer settings
3.9.2.1 To calculate the timer setting
1. Calculate the dimension of your lawn in m
2
yd .
2 2
2. Divide the m / yd of the lawn with the
approximate operation capacity. Refer to
table below.
3. The result is equal to the number of hours
that the product must operate each day.
Note: The operation capacity is approximate and
timer settings can be adjusted.
1 .
2
/
1285 - 002 - 20.08.2019