Advertisement
The loudspeaker binding post accept bare wire, pins,
spades, single and dual-banana plugs.
Always use high quality connections and speaker
wires, and make sure there are no loose fi ttings or
stray wire strands. Connect the positive speaker-level
output of your power amplifi er or receiver to the
positive (red) input of the loudspeaker.
Connect the negative speaker-level output of your
power amplifi er or receiver to the negative (black)
input of the loud speaker.
Make sure that the positive and negative connections
do not touch, or this may damage your your power
amplifi er. Gently pull on the wires to make sure they
make a secure connection.
If you have banana-type connectors on your speaker
wire, tighten the binding post before inserting.
On the binding post cup located on the rear of the
CRM-2 is the Boundary Compensation Switch. This
switch compensates for the bass and mid-bass
loading that occurs when a loudspeaker is wall
mounted, compared to when it is placed away from
a wall. Switch it to the right when the CRM-2 is used
with the CRM Stand Kit.
Binding Post
Cup
Sunfire
1300 New Circle Rd.
Suite 150
Lexington, KY
40505
9. Move the loudspeaker/stand assembly into
position in your room. Make sure that the speaker
wires pass through the slot in the base when you
set it down.
10. Test that the loudspeaker is working correctly.
If your home theater processor or receiver has a
test tone system, try sending test tones through
all of the loudspeakers in your system to check for
correct operation.
Boundary Compensation
Switch
Binding Post
Tel (859) 514-8290
Fax (859) 269-7972
www.sunfire.com
Manual part# 913-158-00 Rev A
Slot
Wires
Advertisement
