Fm And Am Tuner Operation - Sunfire TGR-401-230 User Manual

CHAPTER 5

FM and AM Tuner Operation

The supplied AM and FM antennas
must be connected to the TGR-401
antenna terminals, or no stations will
be tuned.
The internal AM and FM tuners are
se lect ed either by pressing Input and
rotating the manual selector on the
front panel, or by touching the AM or
FM buttons in the re mote's TGR-401
page 2. The front panel display will
change to show the frequency of the
last station you were lis ten ing to.
The FM tuner can tune sta tions
from 87.5 MHz to 108.0 MHz in 0.2
MHz steps (.05 MHz steps for some
in ter na tion al mod els). The AM tuner
range is 530 kHz to 1710 kHz in 10
kHz steps (531 kHz to 1710 kHz in
9 kHz steps for some in ter na tion al
models).
1. Press the remote's MAIN button
to make sure the display is on the
main display menu.
2. Press the TG401 de-
vice button to set the
remote to operate
your TGR-401. The
display chang es to
show the TGR-401
input se lec tions.
3. Press PAGE to
reach page 2. This
allows selection of
the SIRIUS tuner,
FM and AM tuner,
TNMOD and SCAN.
TNMOD lets you use
the number keys
either to enter the station frequen-
cy directly, or to enter the preset
station number. TNMOD is also
available in Zone 2.
SCAN lets you scan up to the next
tunable station. It will remain there
for 5 seconds before scanning
up to the next station. Press the
Navigation SEL button to select a
the currently-playing station.
46
ON
MAIN
PAGE FAV
MAIN
PAGE
PREV
MUTE
CH
VOL CH
GUIDE
MENU
INFO
MENU EXIT
NAV UP
MODE SEL
NAV DOWN
1 3
2
4 6
5
7 9
8
+10 0
ENT
4. Various remote buttons also oper-
ate the AM and FM tuner:
• NAVIGATION KEYPAD - multifunc-
tional for setup menu navigation
and AM/FM tuning.
• NAV UP - Tunes up one frequency
step at a time. If you hold it down,
it will scan up to the next station.
• NAV DOWN - Tunes down one fre-
quency step at a time. If you hold it
down, it will scan down to the next
available station.
• NAV SELECT - Select a station.
• INFO - Show the current station
frequency and preset number, or
the listening mode.
• MENU - Enter the OSD Setup
menu where FM and AM presets
can be con¿ gured.
• CH UP/DOWN - Tunes up and
down through preset list. The list is
created in the preset menu within
the setup menu.
• NUMBER KEYS - These allow you
to enter the actual frequency of
the station directly. If you press TN-
OFF
MOD, you can enter station preset
numbers instead.
5. To operate FM/AM
ZONE 2
in Zone 2, select the
TGR401
Zone 2 button, then
Zone 2's ¿ rst page
will show the FM/AM
input selectors.
CH UP/DOWN
Changing Modes
INFO
1. Press the INFO button until the
front panel display shows the cur-
MODE
rent surround mode. Then use the
NAV SELECT
mode buttons to select a mode.
Saving Presets
NUMBER KEYS
The OSD preset menu is used to
enter the preset number and frequen-
cy of your favorite radio stations.
MAIN MENU
TRIMS
TONE CONTROLS
MODES
PRESETS
SETUP
PRESETS
AM/FM
SIRIUS
AM/FM
PRESETS
01 FM
02 FM
03 FM
04 AM
05 AM
06 NONE
.
40 NONE
SIRIUS
PRESETS
01
02
03
04
05
.
40
1. In the AM/FM preset menu,
press the remote's center navi-
gation select (SEL) to choose
AM or FM, or reset a preset to
NONE.
2. Use the navigation up or down
to move to the preset number,
for example, preset 01.
FREQ CHOICES
107.50 AM/FM, FREQ/NONE
98.30
99.90
1230
610
CHANNEL CHOICES
1 1–223/NONE
223
NONE
NONE
NONE
NONE
User's Manual