Installation - Polar Electro CF760 Instruction Manual

UK

Installation

Note: If the appliance has
been stored or moved in a
non-vertical position, stand
it in an upright position for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. When positioning the dispenser, maintain
a distance of 20cm (7 inches) between the
appliance and walls or other objects for
ventilation. Increase this distance if the
obstacle is a heat source.
3. If necessary, adjust the screw legs of the
dispenser to stabilise it.
Assembly/Disassembly
1. Insert the large rubber gasket into the bottom
of the tank [Fig. 1].
1
2. Holding the top and bottom of the tap lever,
gently bend the lever in the middle [Fig. 2].
3. Push the two hooks at the back of the tap lever
into the slot in the front of the tank and drop
into place [Fig. 3].
4. Lower the tank on to the cooling column.
Locate the four feet on the bottom of the tank
to the mounts on top of the cooling unit.
Note: Lubricate the gasket with
a small amount of water if the
gasket is too tight.
4
CF760_CF761_ML_A5_v8_20191014.indb 4
2 3
Tank
Hooks
Front
5. Roll the O-ring down
4
the tap shaft [Fig. 4]
and insert thin end
first into the hole in
the tank.
6. Ensure the bottom
of the tap slots into
the gap in the tap
lever.
7. Hang the drip tray from the slots on the front
of dispenser [Fig. 5].
5
8. Securely fix the lid to the tank.
Lever
Slot
2019/10/14 17:31