Ironing; Dry Ironing; Steam Ironing - Sunbeam 4061 User Manual

Ironing

Dry Ironing

Make sure that the Steam Lever is set to 0/OFF.
1.
Plug the cord into a 120 volt AC outlet.
2.
The Power Indicator will light.
Turn the Fabric Select Dial to the dry ironing
3.
fabric setting you desire and allow the iron to
heat for 2 minutes. While the iron is heating,
make sure it is sitting on its heel rest on a
stable, protected surface.
4. If using the SHOT OF STEAM
water reservoir must be at least 1/4 full of
water.
Tip: Refer to the Ironing Guide on Page 12
for the recommended setting for your fabric.

Steam Ironing

Follow the instructions for "Filling
1.
the Water Reservoir" on Page 3.
Plug the cord into a 120 volt AC outlet.
2.
The Power Indicator will light.
Turn the Fabric Select Dial to the steam ironing
3.
fabric setting you desire (Linen, Cotton, Wool
and allow the iron to heat for 2 minutes.
or Silk)
While the iron is heating, make sure it is sitting
on its heel rest on a stable, protected surface.
Tip: Refer to the Ironing Guide on Page 12
for the recommended setting for your fabric.
After the iron has heated (2 minutes), turn
4.
the Steam Lever to desired steam setting.
Important: When not ironing, always set the Steam
Lever to 0/OFF and the Fabric Select Dial to OFF.
4
ironing
® feature, the