To Fill The Water Reservoir; Dry Ironing; Steam Ironing - Sunbeam Steam Master 4211 Instruction Manual

T F W
O ILL THE
1. Make sure the iron is unplugged. Set the Steam Lever to
Dial to OFF.
2. Lift the Water Fill Hole Cover.
3. Fill water cup with water. Pour water into iron water reservoir. Do not fill water reservoir
beyond maximum fill level.
W : To prevent the risk of burns, be careful when filling a hot iron with water.
ARNING
Hot metal parts, hot water and steam can cause injuries.
D I
RY RONING
1. Make sure the Steam Lever is turned to the
2. Plug the cord into a 120-Volt AC outlet.
3. Turn the large Fabric Select Dial to the fabric setting you desire (Silk or Synthetics).
Allow the iron to heat for 2 minutes. While the iron is heating, make sure it is sitting
on its heel rest on a stable, protected surface.
N : While the Steam Lever is turned to the
OTE
OF STEAM ® or SPRAY MIST
T : Refer to the Ironing Guide for the recommended setting for your fabric.
IP
S I
TEAM RONING
1. Follow the instructions for "Filling the Water Reservoir".
2. Plug the cord into a 120-Volt AC outlet.
3. Turn the large Fabric Select Dial to the fabric setting you desire (Synthetic, Silk, Linen,
Cotton or Wool). Allow the iron to heat for 2 minutes. While the iron is heating,
make sure it is sitting on its heel rest on a stable, protected surface.
4. Allow the iron to heat for 2 minutes, and then turn the Steam lever to the appropriate setting.
T : Refer to the Ironing Guide for the recommended setting for your fabric.
IP
I : When not ironing, always set the Steam Lever to
MPORTANT
Select Dial to OFF.
R
ATER ESERVOIR
® feature. Please make sure the water reservoir is 1/4 full of water.
O /Off (Dry) and the Fabric Select
O /Off (Dry) setting.
O /Off (Dry) setting, you may still use the SHOT
O /Off (Dry) and the Fabric