Troubleshooting - Black & Decker 1 VPX VPX1201 Instruction Manual

90520993 VPX1201 VPX Dril#E4FEB
Problem
• Unit will not start.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
For assistance with your product, visit our website www.blackanddecker.com for the location of the
service center nearest you or call the BLACK & DECKER help line at 1-800-544 6986.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer
or authorized service center. If you need assistance regarding accessories, please
call: 1-800-544-6986.
WARNING:
The use of any accessory not recommended for use with this tool could
be hazardous.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
lithium ion battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid
by Black & Decker.
RBRC™ in cooperation with Black & Decker and other battery users, has established
programs in the United States to facilitate the collection of spent ion batteries. Help
protect our environment and conserve natural resources by returning the spent lithium ion
battery to an authorized Black & Decker service center or to your local retailer for
recycling. You may also contact your local recycling center for information on where to
drop off the spent battery.
RBRC™ is a registered trademark of the Rechargeable Battery Recycling Corporation.
7/11/07 9:48 AM

TROUBLESHOOTING

Possible Cause
• Battery pack not installed properly.
• Battery pack not charged.
• Charger not plugged in.
• Surrounding air temperature.
• Battery pack too hot or too cold.
12
Page 12
Possible Solution
• Check battery pack installation.
• Check battery pack
charging requirements.
charger until red LED appears.
• Plug charger into a working
outlet. Refer to "Important
Charging Notes" for more
details.
• If chargers are daisy chained
together check all connections.
• Check current at receptacle
by plugging in a lamp or other
appliance.
• Check to see if receptacle
is connected to a light
switch which turns power off
when you turn out the lights.
• Move charger and battery
to a surrounding air
temperature of above 40
degrees F (4,5°C) or below
105 degrees F (+40,5°C).
• The charger will not
charge a battery pack if the
cell temperature is below
approximately 32° F (0° C)
or above 140° F (60° C).
The battery pack should be
left in the charger and the
charger will begin to charge
automatically when the cell
temperature warms up or
cools down.