Burner Caps And Heads; Burner Bases; Electrodes - Samsung NA30 5310F Series User Manual

Care and cleaning of the cooktop

Burner caps and heads

NOTES
Before removing the burner caps and heads, remember their size and location.
Replace them in the same location after cleaning.
Wash burner caps and burner heads in hot, soapy water and rinse with clean
running water. You may scour with a plastic scouring pad to remove burned-on
food particles.
Use a sewing needle or twist tie to unclog the small holes in the burner head, if
required.
CAUTION
• Do not wash any burner parts in a dishwasher.
• Do not use steel wool or scouring powders to clean the burners.

Burner bases

CAUTION
The burner bases cannot be removed for cleaning.
Round burner base
Electrode
18 English
NA5300R_DG68-01132A-00_EN.indd 18
Make sure that no water gets into the
burner bases and the brass gas orifices.
Wipe clean with a damp cloth. Be careful
not to scratch, deform, or damage the
bases. Allow them to dry fully before using.

Electrodes

CAUTION
Do not attempt to remove the electrode from the cooktop or burner bases.
Be careful not to push in any cooktop
controls while cleaning the cooktop. A slight
01
electrical shock might result which could
cause you to knock over hot cookware.
Make sure that the white ceramic electrodes
in the cooktop are clear of soil and dry.
02
Clean the metal part of the electrode with
a soft cloth. Do not use water to clean the
igniters.
01 Clean this metal part
02 Do not clean this white ceramic Before reassembling the surface burners,
push down gently on each of the white
part with an emery board
ceramic, electrodes to make sure they are
pressed against the burners bases.
Do not attempt to remove the electrode
from the cooktop.
NOTE
2019-04-19 4:46:13