Advertisement
INSTRUMENT PANEL
1
2
3
5
4
4 - 5
4 - 5
1
POWERSCOPE
POWER TELESCOPING,
POWER-FOLDING, POWER
EXTERIOR MIRRORS*
To telescope both mirrors at the
same time, make sure you switch
6
your vehicle on (with the ignition
in accessory mode or the engine
running) and then:
1. Press and release the power
fold button
2. Press the adjustment control to
position the mirrors.
•
Press the left arrow
extend the mirrors out. Press
the right arrow
mirrors in.
•
Press the up or down arrow
to fold the mirrors
toward the window glass.
Press the up or down arrow
to fold the mirrors out.
Note: Moving the mirrors 10 or
more times within one minute, or
repeated folding and unfolding
of the mirrors while holding the
control down during full travel,
may disable the system to protect
the motors from overheating. Wait
approximately three minutes with
the vehicle running, and up to
10 minutes with the vehicle off,
for the system to reset and for
7
8
function to return to normal.
2
SPOT LAMPS CONTROL*
®
The spot lamps are on the
forward-facing side of the exterior
mirrors. With the lighting control
switch in the parking lamps
position, press the buttons located
above the lighting control switch to
activate the left-hand or right-hand
side spot lamps. Once switched
on, the spot lamps light the area
in front of and to the side of your
.
vehicle. Adjust the aim of the spot
lamps by moving the exterior
mirrors' positions.
Note: The spot lamps turn off
to
when you reach a speed of 6 mph
(10 km/h).
to retract the
3
LIGHTING CONTROL
Headlamps off.
Parking lamps on.
Headlamps on.
Autolamps on.
Automatically switches the
exterior lamps on or off
based on available daylight.
Fog lamps on. Press the
control to switch the fog
lamps on or off. You can
switch the fog lamps on
when the lighting control is
in any position except off
and the high beams are
not on.
*if equipped
4
6
ELECTRIC PARKING BRAKE*
INFORMATION DISPLAY
CONTROLS*
On certain models, the electric
parking brake replaces the
Monitor and control important
conventional foot brake. The
vehicle information and features
operating switch is on the
through the information display.
instrument panel, to the left
•
Press the up or down arrows
of the steering column.
to scroll through and highlight the
To apply the electric parking brake,
options within a menu.
make sure the transmission is
•
Press the right arrow
to enter
locked into park (P), and then
into a sub-menu.
pull the
switch up. The brake
•
system warning lamp flashes then
Press the left arrow
to exit
lights to confirm that you applied
a menu.
the brake.
•
Press OK to choose and confirm a
To release the electric parking
setting or message.
brake, switch the ignition on, press
the brake pedal, and then manually
You can even customize your views
press the
switch down. The
using MyView.
brake system warning lamp then
Refer to the Information Displays
turns off to confirm the parking
chapter in your Owner's Manual for
brake is released.
more details.
5
ADJUSTING THE PEDALS*
7
ADAPTIVE CRUISE CONTROL*
Move the brake and accelerator
Automatically adjust your speed to
pedals using the control. The
maintain a set distance between
vertical control is to the left of
your vehicle and the vehicle in front
the steering column and on the
of you in the same lane. Set the
instrument panel. The horizontal
gap distance between your vehicle
control is on the left side of the
and the vehicle in front of you by
steering column.
pressing the
and
controls on
Press the left arrow
to move the
the steering wheel.
pedals away from you.
If your vehicle follows a vehicle
Press the right arrow
to move the
to a complete stop and remains
pedals closer to you.
stopped for less than three seconds,
Adjust the pedals only after
your vehicle accelerates from a
stopping your vehicle and placing it
stationary position to continue to
in park (P).
follow the vehicle.
If the vehicle you are following
comes to a complete stop and
remains stopped for more than
three seconds, press RES+ or the
accelerator pedal to continue follow
the vehicle.
Note: Driving aids do not replace
the need to watch when the
vehicle is moving and brake where
necessary. Refer to the Cruise
Control chapter in your Owner's
Manual for more details.
8
POWER TILT-TELESCOPE
STEERING COLUMN*
Use the control on the side of
the steering column to adjust
the position.
To tilt: Press the top or bottom of
the control.
To telescope: Press the front or
rear of the control.
*if equipped
Advertisement
