Disassembly And Reassembly; Disassembly Of Main Unit - Samsung ST70 Service Manual

9. Disassembly and reassembly

9-1 Disassembly of main unit

Precaution for disassembly/reassembly
1. Set up the repair table where the anti-static mat is installed to disassemble and reassemble the camera.
2. When handling the key PCB of the camera, wear the anti-static band on the wrist to prevent any error from
static electricity.
3. When handling key parts, be careful of the following.
Part
F PCB Type
CCD and IR CUT
PCB Type
CONTACT Type
SAMSUNG
When assembling the F PCB to the CONNECTOR with a pin set, be careful not to cause dents or
tears on the PCB.
When handling the parts, be careful not to leave any fingerprints.
Use the pin set with soft tips.
When cleaning the parts with alcohol, be careful not to cause any stains.
Do the repair work in a dust free environment.
Always use the anti-static mat and wrist band, as the parts can be damaged from static electricity
from the hand.
Be careful of damage of deformation of parts from the pin set.
<Table 9-1>
Precaution
Disassembly and Reassembly
9-1