Assembly For Lead Wire - Panasonic KX-DT543-B Service Manual

9.3.

Assembly for Lead wire

Perform this process in reverse when taking the unit apart.
**LEAD WIEW STYLING**
WIRE （ORANGE）
WIRE （BLUE）
PCB HOLDER
**LFW-SOLDER、 PART STICKING**
White modle only
ACETATE TAPE
(Width=10mm,L=15mm)
OK
NG
A : Confirm that LEAD WIRE does not
run onto rib of PCB HOLDER.
PCB HOLDER PCB HOLDER PCB HOLDER
Reference line
B : Stick on the side of PCB HOLDER
ACETATE ACETATE ACE
TAPE TAPE TAPE
(20mm) (20mm) (20mm)
Orange Orange Orange
PCB HOLDER PCB HOLDER PCB HOLDER
Ope BOARD Ope BOARD Ope BOARD
Blue Blue Blue
Orange Orange Orange
Locate the lead wire as shown in a figure.
Rib Rib Rib
A A
B B
ATE
Main BOARD Main BOARD Main BOARD
Blue Blue Blue
Solder Solder Solder
Main BOARD Main BOARD Main BOARD
Solder Solder Solder
Blue Blue Blue
Orange Orange Orange
Orange Orange Orange
39
KX-DT543/KX-DT543-B/KX-DT546/KX-DT546-B
The connector is surely inserted up to the
root and locked.
A : Insert Cable to under PCB as fig
B : Stick tape following to the standard line
A B
Blue Blue Blue
ACETATE
TAPE
(20mm)