Advertisement
Installing Optional Accessories
Connecting Accessories
1
"8" shaped com-
posite attachment
clip on the back
of the accessory.
Place the
3
widest end of
over the green
connection
button.
To remove,
5
reverse
procedure by
gripping 1" loop
and pulling
upward.
Installing Attachment Points to Belts
To install the belt attach-
ment clip onto a belt,
Make sure the smaller
shape is at the top and
to the inside, then slide
onto belt.
To install the belt attach-
ment clip onto a belt, sim-
ply slide on to the belt.
Us er In stru ctio ns - Engli sh
Miller integrated accessories have a weight limit of 25 lbs. when con-
nected via the composite link. For loads heavier than 25 lbs., connecting
to a belt via the tunnel loop is recommended for more even weight distri-
bution. The combined weight of the harness user, and all attached
tools and accessories should not exceed the maximum capacity of
the fall protection system being used.
Identify the
2
green button
attachment
point on the
belt or harness
that will be
used.
Push the acces-
4
sory downward
until you feel it
snap into place.
7
Advertisement
