Panasonic CF-AX2 Series Operating Instructions Manual page 26

Installing Software
D Click [Restart] of the "Manage the TPM security hardware" screen.
The computer will restart.
E When "TPM configuration change was requested to ..." is displayed, press F12.
The desktop screen appears.
F When "TPM is ready" appears, click [Close].
1 Turn on the computer, and press
The Setup Utility starts up.
If the [Panasonic] boot screen is not displayed, turn on the computer while holding down F2 or Del.
If the password is requested, enter the Supervisor Password.
2 Write down all of the contents of the Setup Utility and press
At the confirmation message, select [Yes] and press Enter.
3 Press .
F10
At the confirmation message, select [Yes] and press Enter.
The computer will restart.
4 Press or
F2
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
5 Select the [Exit] menu, then select [Recovery Partition] and press
6 Click [Reinstall Windows] and click [Next].
The License Agreement screen appears.
7 Click [YES].
The License Agreement screen appears.
8 Click [Yes, I agree to the provisions above and wish to continue!] and click [Next].
9 Select the setting and click [Next].
[Reinstall Windows to the whole Hard Disk to factory default.]
Select this option when you want to install Windows to the factory default. After installation, you can create a
new partition. For how to create a new partition, refer to "To change the partition structure" (
[Reinstall to the System and OS partitions.]
Select this option when the hard disk has already been divided into several partitions. For how to create a new
partition, refer to "To change the partition structure" (
You can keep the partition structure.
*1
This does not appear if Windows cannot be installed to the recovery partition and the area usable by Windows.
10 At the confirmation message, click [YES].
11 <For MUI OS model>
Select language and OS (32bit or 64bit), then click [OK].
<For localized OS model>
Select OS (32bit or 64bit) and click [OK].
12 At the confirmation message, click [YES].
Installation starts according to the instructions on the screen. (It will take approximately 20 minutes.)
Do not interrupt installation, for example by turning off the computer or pressing Ctrl + Alt + Del.
Otherwise installation may become unavailable as Windows may not start up or the data may be corrupted.
13 When Ending process screen is displayed, click [OK] to turn off the computer.
14 Turn on the computer.
If the password is requested, enter the Supervisor Password.
15 Perform the "First-time Operation" (
16 Start the Setup Utility and change the settings as necessary.
17 Perform Windows Update.
Using Recovery Disc
Use the Recovery Disc in the following conditions.
• You have forgotten the administrator password.
• Installation is not complete. The recovery partition in the hard disk may be broken.
• To change OS from Windows 7 to Windows 8, or vice versa.
26
while [Panasonic] boot screen is displayed.
Del
or while [Panasonic] boot screen is displayed.
F2 Del
*1
page 17).
page 15).
.
F9
.
Enter
page 17).