Advertisement
1. Remove Lockring (6) and unscrew cup nut (3).
2. Hold unit in vertical position and remove thrust bearing (8), Washer (7) & Washer (7A).
3. Carefully invert unit over a clean receptable, pressure springs (9 & 10) will drop out.
4. From the lower end remove Chuck Nut (41),Collet (46) if necessary then remove E-Type Circlip (43A) and Loosen L-R stud (43) to remove Nuts(42)
(For Model HR).
5. Remove Circlip (27), Stop Arm (44), Circlip (16) and Bearing Cover (40).Do not remove Circlip (27) which holds bearing.
6. Lift out complete gear – carrier sub-assembly with spindle unit.
7. Remove Gear Ring (18), key (19) and Spacer (17).
8. Remove Lockring (35), Washer (34), Ball Carrier (32), Balls (33) and Spring (31).
9. Lift out Reverse Gear (22) and Spring (23).
10. Remove Lockring (30), Expansion Spring (29) and Washer (25) for relieving spindle unit from Carrier sub-assembly.
11. Remove Circlip (16) for disassembling clutch sub-assembly. Invert the Body over a clean receptable. Lift off pressure plate (11), Balls (14),
Clutch Driver (12). For reassembly pack grease in clutch sub-assembly, so Pressure Plate (11) will stay in place while reassembling Clutch
Bearing assembly.
12. Do not disassemble Ball bearings (15 & 26).
13. Do not disassemble pinion (20) – Carrier (24) sub assembly.
1. Clean and lubricate all parts requiring lubrication thoroughly.
2. Reverse procedure for assembly.
ASSEMBLY PROCEDURE
INSTRUCTIONS FOR DISASSEMBLY
INSRTUCTIONS FOR ASSEMBLY
Advertisement
