Getting Started; Device Overview; Tripod Adjustments; Installing The Tripod - Garmin Xero S1 Owner's Manual

Getting Started

This device is intended to provide accurate aiming solutions
based on calibrated measurements of current conditions only.
Depending on your environment, conditions may change rapidly.
Changes in environmental conditions, like wind gusts or
downrange winds, may have an effect on the accuracy of your
shot. Aiming solutions are suggestions only based upon your
input into the device. Always allow a margin of safety for
changing conditions and reading errors.
Always inspect your equipment before using a firearm. You are
responsible for understanding and complying with any
applicable regulations for using a firearm.
Always understand your target and what lies beyond your target
before taking a shot. Failure to account for your shooting
environment could cause property damage, injury, or death.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
The Xero S1 Trapshooting Trainer helps you improve your
trapshooting score by tracking a clay target and your shot using
a combination of sensors. The device can track orange, green,
and pink clays in both 108 mm and 110 mm sizes. Other sizes
and colors are not supported.
NOTE: This device is intended to track one clay and one shot at
a time. Doubles trap and trap games that allow multiple shots
are not supported.

Device Overview

Press to turn on the device.
Hold to turn off the device.
Power button
Connect a compatible USB cable to charge
the device or transfer data using your
Micro-USB power and
computer.
data port (under weather
cap)
Getting Started
WARNING
Swipe to scroll through features, data
screens, and menus.
Touchscreen
Tap to select.
Remove before using the device.
Replace when not in use.
Protective cover

Tripod Adjustments

The tripod adjustment controls are located on the underside of
the Xero S1 device.
Adjusts the angle of the Xero S1 device on
the tripod ball mount
Tripod adjustment
button
Opens the socket to install or remove the
tripod ball mount
Tripod release lever

Installing the Tripod

1 Screw the tripod ball mount
NOTE: You should tighten the tripod ball mount so it does not
move during use. The tripod ball mount uses 1/4"-20 thread
size and is compatible with most tripods. For best
performance, do not raise the device beyond waist height or
a total height of 1.2 m (4 ft.).
2 Completely depress and hold the tripod release lever
onto the tripod assembly
.
.
1