Stanley Compulevel User Manual page 5

47855 CompuLevel
COMPULEVEL
To use COMPULEVEL
1) Secure the base unit on its back at any convenient location and pull
from the reel ample cord to cover the area to be measured. The cord
will communicate elevation information from the base unit to the
measurement module.
2) If desired, attach the unipod to the measurement module to avoid
bending to measure. The unipod is not required for operation.
3) Turn on the unit and zero with the ZERO button at any site reference or
benchmark within COMPULEVEL's 200' horizontal, and + 20' vertical
range. Although it is not necessary for the base unit to be level, it must
be secure.
Note: If the base unit moves, you must re-zero the measurement module
at the bench mark before continuing.
Parts of the COMPULEVEL
2. Pull back 1" with 4 fingernails each side.
3. Grip measurement module and boot and pull off.
Cord
Reel
Staking
locations*
BASE UNIT
*Stake through handle area if unipod
remains in base unit
6/11/07 11:14
TM Basics continued
TM :
TM
To remove the boot:
1. Place against chest
Typically on back
side during use
Storage
Measurement module
docking area
Display
Keypad
Cord
MEASUREMENT
MODULE
BASE UNIT
REAR VIEW
Page 4
Boot
Battery
(THIS IS EASIER WHEN WARMED)
Uni-pod
Reel
retaining
screw
Compulevel TM Measurement system • 4
Serial Port
Uni-Pod port
Two
stakes
Three
feet
Quick
reference
guide