Battery; Battery Charging; Battery Removal/Installation - Standard Communications Hx 350s Owner's Manual

5
To avoid risk of explosion and injury, CNB350/CNB350AS battery pack should
only be removed, charged or recharged in non-hazardous environments.

5.1 BATTERY CHARGING

To check the charge status, install the battery and press the PTT switch
while observing the BATT indicator. (see page 7)
The battery charge system (CCA250 and CWC230) supplied with the
transceiver recharges a completely discharged CNB350/CNB350AS
battery pack in about 15 hours.
Battery pack should not be charged with the supplied battery charge
system for longer than 16 hours.
The CSA280 is an optional desktop rapid charger that charges the CNB350/
CNB350AS battery pack in approximately 1.5 hours. The transceiver and its
battery can be placed into this charger, and the charger set to rapid charge.
Battery condition is automatically sensed: when full charge is achieved, the
charger switches to trickle-charge mode to maintain the charge indefinitely
without harm to either the battery or the charger. This charger and an extra
battery are highly recommended.

5.2 BATTERY REMOVAL/INSTALLATION

Figure 4. Installing the battery
HX350S
CAUTION
1. Turn the transceiver off.
2. To remove, turn the battery lock screw
counterclockwise 5 or 6 turns, and pull
the battery pack until it slides out.
3. To install, slide the battery pack into
the battery cavity until fully inserted,
and turn the battery lock screw
clockwise until hand-tightened. (see
figure 4)
Owner's Manual

BATTERY

page 17