Getting Started - Remington PG350 Quick Start Manual

GETTING STARTED

CHARGING YOUR APPLIANCE
• Before using your groomer for the first time, charge for 14-16 hours.
• Ensure the product is switched off.
• Place your groomer into the stand, connect the adaptor to the product and then to
the mains.
• The charging indicator will illuminate.
• Your appliance cannot be overcharged. However, if the product is not going to be
used for an extended period of time (2-3 months), unplug it from the mains and
store.
• Fully recharge your appliance for 16 hours when you would like to use it again.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 14-16 hours.
INSTRUCTIONS FOR USE
ATTACHING AND REMOVING GUIDE COMBS
NOTE: Always ensure the groomer is switched off before changing any attachments.
To attach:
With the trimmer blade facing away from you, slide the guide comb on top of the trimmer
blade and click into position.
To remove:
With the trimmer blade facing away from you, carefully push the guide comb away from
the trimmer blade.
BEFORE YOU BEGIN
• Comb facial hair with a fine comb before you start trimming.
• Hairs should be dry and without any waxes or lotions before using the groomer.
TO THIN AND TAPER THE BEARD/MOUSTACHE
• Attach a guide comb to the 30mm trimmer blade. If you are trimming for the first
time, start with the maximum trimming length setting.
• Turn on the product and place the flat top of the trimmer comb against the skin.
• Slowly slide the personal groomer through the hair. Repeat from different
directions as necessary.
• Start trimming under the chin, following the jawbone line. Work toward the ear and
upper beard line using an upward motion.
4