Troubleshooting - Black & Decker CM1010B Use And Care Book Manual

CARAFE CARE
A damaged carafe may result in possible burns from a hot liquid. To avoid
breaking:
• do not allow all liquid to evaporate from the carafe while on the "Keep Hot"
carafe plate or heat the carafe when empty.
• discard the carafe if damaged in any manner. A chip or crack could result in
breakage.
• do not use abrasive scouring pads or cleansers, they will scratch and weaken
the glass.
• do not place the carafe on or near a hot gas or electric burner, in a heated
oven or in a microwave oven.
• Avoid rough handling and sharp blows.
POWER CORD STORAGE
For your convenience, the cord storage gives you the
flexibility to use the exact cord length needed and keep
the rest stored in the coffeemaker.
To increase the length, grasp the power cord and
gently pull it away from coffeemaker. To store excess
cord, feed it into the coffeemaker (Q).
Important: Do not grasp and pull the power plug.
Q
RISK OF FIRE OR ELECTRIC SHOCK. DO NOT OPEN.
The lightning symbol refers to "dangerous voltage"; the exclamation symbol
refers to maintenance instructions. See below.
Warning: To reduce the risk of fire or electric shock, do not remove the cover
of the coffeemaker. There are no user-serviceable parts inside. Repair should
be done by authorized service personnel only.
2
WARNING

TROuBLESHOOTING

PROBLEM POSSIBLE CAuSE
Coffeemaker does Coffeemaker is not
not turn on. plugged in.
Coffeemaker is Water reservoir may
leaking. be overfilled.
Carafe may not be
correctly placed
"Keep Hot" carafe
plate.
Brewing takes too Coffeemaker might
long. need cleaning.
Coffee is not brewing. Water reservoir
might be empty.
Coffeemaker brews There may be no
clear water. coffee grounds in
removable filter
basket.
Filter basket does not Removable filter
close. basket may not be
correctly placed.
Filter basket Carafe may be
overflows. improperly placed
on "Keep Hot" carafe
plate.
Grounds in brewed Filter and/or filter
coffee. basket are not
properly placed.
SOLuTION
Check to be sure appliance is
plugged in to a working outlet
and the oN/oFF button is
powered oN.
Make sure water reservoir has
not been filled beyond MAX fill
line.
Make sure carafe is placed
correctly on "Keep Hot" carafe
plate and is centered under
filter basket holder.
Follow procedure in CARe
ANd CleANING.
Make sure water reservoir
has sufficient water to brew
desired number of cups of
coffee.
Add sufficient amount of
coffee grounds to paper or
nylon mesh filter in removable
filter basket.
Remove filter basket and
replace correctly into holder.
Remove carafe and insert so
that carafe rests comfortably
within grooves on "Keep Hot"
carafe plate.
Insert paper liner or nylon
mesh filter into filter basket
and insert basket properly into
holder.