Table of Contents
Advertisement
Terminal Emulation with Console
B
Cable
Console Port
To Connect to the CLI
Requires: Terminal emulator such as PuTTY, Tera Term, or a terminal server.
1. Connect the appliance console port to the management computer using the provided
console cable.
2. Start a
terminal emulation program
port
and use the following settings:
Baud Rate:
9600
8
Data bits:
Parity:
None
Stop bits:
1
Flow Control:
None
3. Press
Enter
on your keyboard to
connect to the
4. Login using username
"admin"
and
configuring your device.
Get started by typing
"?"
for a list of available commands.
Begin typing a command and type
For example
"config ?"
shows the lowest level of configuration options.
6
Serial Port
on the management computer. Select the
CLI.
no
password. You can now proceed with
"?"
for a list of available ways to complete.
General Installation
3
The FortiADC unit can be mounted in any standard
rail mount kit.
Please read the "Cautions and Warnings" prior to installing your device.
To install the FortiADC unit into a rack:
1. Ensure that the FortiADC unit is placed on a stable surface prior to
installation.
2. Assemble the
and the rack installation instructions in
3. Verify that the
the unit is level.
4. Connect the provided
COM
5. Plug the other end of the power cables into separate power sources, such as
uninterruptible power supplies
6. Insert one end of the provided
FortiADC unit. Insert the other end to a
Internet.
7. Press the
Do not place heavy objects on the unit.
19 inch rack
rails
and install the system in the rack following the
Rail Installation
spacing
around the FortiADC unit conforms to requirements and that
power cables
to the system.
(UPS) or
power distribution units
Ethernet cable
into one of the Ethernet ports on the
router or switch
power button
on the system to turn on the device.
unit with the provided
rack-mount
safety instructions
(p. 8).
(PDU).
that is connected to the
7
Advertisement
Table of Contents
