Sharp COMPET CS-363 Series Instruction Manual page 68

f
[BJ
Halt key
Gives instruction for temporary stop of the program. To obtain an intermediate result of a
calculation or to input a variable number on the way of calculations, this key is operated.
Then the program operation temporarily stops. Unless this key is operated, operation
proceeds from No.1 step to END instruction without stop and it is not possible to input a
variable number on the way. At the step to input a variable number, this key must be
operated with out fail. To input a constant number, operate the numeral keys according to
the calculation formula. In this case, the number whose key was operated is programmed as
a constant number.
~
End key
Gives the end instruction to the program memory. Refer to page66 "(b) END instruction".
o
Jump start key
Gives the jump start instruction to the program memory. Refer to page89 "D . JUMP
FUNCTION".
@
Jump stop key
Gives the jump stop instruction to the program memory. Refer to page-89 "D. JUMP
FUNCTION".
IRECORDI
IVERIFYI} Card control keys
I ENTER
I
Used when program operation is performed by using a magnetic card. Refer to page1 04"2.
Card control key" .
3. Instructions
All keys except
§] ,
~
and card control keys can be programmed as an instruction.
However, there are two kinds of instructions, namely, one-step instruction and two-step
instruction.
One-step instruction
19 ,
~ ,
E]
, [J , lQJ-
[§ ,
8 , 0 ,
°
, 0 , 0 ,
[BJ ,
~
It is possible to store the program independently by operating these keys.
Two-step instruction
El (
)~
B ), El ( ), EJ ( ), 0 ( ),
@ ( ),
~ ~
It is possible to store the program when
E] , [J , lQJ- [§
keys are touched following such
instructions as
0 , El El , El , 0
and @. Above operations become the
instructions for designation of memory register or jump number, otherwise, they are
programmed as constant numbers.
*
El
[1J ,for example, would tell the computer to clear No.1 memory register.
63