Limited Warranty - Heatmaster G Series Operation And Maintenance Manual

SteelTech Inc . warrants to the original owner of the
G Series outdoor furnace that it is free from defects in
workmanship and material, which could cause a leak or
malfunction of the firebox or water jacket, and against
corrosion (if the instructions in the owners manual for
water treatment and maintenance are followed) for the life
of the furnace towards the purchase of a new HeatMaster
furnace, in the following pro-rated schedule .
Warranty schedule
Coverage in the initial 5 years is 100%
Year 6 - 7 is 50%
—
Year 8 - 9 is 40%
—
Year 10 - 15 is 30%
—
Year 16 to life is 10%
—
All firebrick used in the furnace carries a 2-year
—
warranty .
In addition, all steel including housing, legs, etc . have a
pro-rated warranty for a period of 10 years with coverage
reducing by 10% per year. Any parts not manufactured
by SteelTech Inc. that are used on the furnace - such as
thermostats, limit switches, pumps, heat exchangers - carry
their own manufacturer's warranty . SteelTech Inc . will not
be liable for the cost of shipping, replacement or repair of
these parts .
If warranty requires removing or replacing of the furnace
or a part on the furnace, SteelTech Inc. is not responsible
for the cost of plumbing, replacement of antifreeze or
water treatment, shipping cost or any other cost other than
the replacement component or furnace . SteelTech Inc .
always has the right to decide if a part or furnace will be
4 Heatmaster G Series Furnace Operating Manual
SS

LIMITED WARRANTY

repaired or replaced and will not be liable for any cost not
authorized by a SteelTech Inc. representative.
SteelTech Inc . does not warranty any damage caused due
to negligence and deterioration due to lack of proper
ongoing maintenance, physical damage caused by abuse
or freeze up, power surges or unauthorized work or
SS
modifications to the furnace.
SteelTech Inc. is not liable for any damage or cost which
may occur from or during the operation of the furnace
or damage incurred due to any heating system failure .
The purchaser assumes all responsibility for the care,
maintenance, and safe operation of the furnace including
adding of approved boiler treatment or water. SteelTech
Inc does not warrant door gaskets, exterior paint or finish.
To qualify for warranty all instructions must be followed
in the operator's manual, water must be tested and
maintained a minimum of once per year, and warranty
registration must be on file at SteelTech Inc. within 30 days
of purchase along with a copy of the original invoice . No
warranty can be approved unless the warranty registration
and water test verifications are on file at SteelTech Inc.'s
office.
The warranty can be voided by operating the furnace in a
manner inconsistent with the owner's manual . SteelTech
Inc . reserves the right to change conditions or warranty at
any time .