Pioneer CDX-P2050VC Service Manual page 55

QQ
3 7 63 1515 0
- Removing the Pickup Unit
1. Insert a short pin into the pickup flexible PCB.
2. Remove the pickup flexible PCB from the connector.
3. Remove the flexible card from the connector.
4. Remove the lead wires of the spindle motor assy and carriage motor assy by removing solder.
5. Loosen the two screws. Lift up the relay PCB as shown in Fig. 9.
Be careful not to excessively pull the tray motor flexible PCB and the relay flexible PCB.
Relay PCB
TE
L 13942296513
6. Remove screws A and then remove the carriage motor assy, lighting conductor, feed screw holder, feed screw and
belt (see Fig. 10).
7. Remove screw B on the main side and the pickup unit together with the guide shaft (see Fig. 10).
www
.
http://www.xiaoyu163.com
Flexible card
Short Pin
CRG motor
Feed screw
Guide shaft (main)
Pickup unit
Guide shaft (sub)
x ao u163
y
i
http://www.xiaoyu163.com
CDX-P2050VC,P2050VN,P2050VS
2 9
8
Q Q
3 6 7 1 3 1 5
Screw A
Motor bracket
Belt
Screw B
co
.
9 4 2 8
Erect
Tray motor flexible
PCB (handle with
care)
Flexible PCB (handle
with care)
0 5 8 2 9 9 4 2 8
Lighting conductor
Screw A
Feed screw holder
m
9 9
Fig.9
9 9
Fig.10
55