Commissioning; Integrating The Link Into The Local Network; Lan; Wlan - Wolf Link home Installation And Operating Instructions Manual

https://www.wolf-
smartset.com/
lan_de
https://www.wolf-
smartset.com/
wlan_de
12

Commissioning

5 Commissioning
5.1 Integrating the Link into the local network

5.1.1 LAN

1) See page 8 for information on how to install the WOLF Link home
or WOLF Link pro
2) Connect the network cable to the router
3) Turn on the power supply of the appliance and connect the WOLF
Link pro to the power
4) After approx. 1 minute, the yellow LED will remain on and a
connection can be established via the home network.

5.1.2 WLAN

1) See page 8 for information on how to install the WOLF Link home or
WOLF Link pro
2) Remove the network cable if connected
3) Turn on the power supply of the appliance and connect the WOLF Link
pro to the power
4) Start the WPS function on your WLAN router by pressing the relevant
button (Wi-Fi Protected Setup, Push Button Configuration)
5) Next, press the button on the WOLF Link home or WOLF Link pro for
3-5 seconds within 30 seconds. Release when the yellow and green
LEDs start flashing. The red LED on the interface module will start
flashing rapidly - if it stays on, the connection has been established
6) After approx. 1 minute, the yellow LED will remain on and a connection
can be established via the home network.
5.1.3 Please refer to www.wolf-smartset.com/faq for other ways in
which you can connect to the local network
5.2 Connecting to the internet
To connect your system to the internet, please follow the instructions
provided by the setup assistant of the WOLF Smartset app.
The setup assistant is available from the menu in the Smartset app.
The app can be downloaded from the following links:
QR code on iOS app
Instructions for setting up the interface without using the Smartset app
are provided at www.wolf-smartset.com/faq.
QR code on Android
3066086_201803