Unpacking Our 15” LCD monitor shall be content with these following items. Make sure you get all these set ready, otherwise contact to your dealer or store which you purchased it. At last, feel free to contact us. 15” TFT LCD Monitor External Univ15 pin D-sub (RGB Analog) input signal cable...
Hardware Installation Be carefully to your LCD monitor, it’s very exquisite but easy to broken. Turn off LCD’s and PC’s power before you set it up. Follow our installation step by step. Input 【1】DC port:This is for connecting the power cable 【2】PC In : This can be connected with the D-Sub 15 pin signal Cable.
Hardware Installation Step by Step Turn your LCD opposite carefully which can see all the connection port. Inset the signal cable such as RGB analog (standard) to its own port, and the other side connects to computer. Inset the Audio connector to its own port, and the other side connects to computer line out. Put AC Adaptor and Power Cord together.
Angle of Inclination In normal condition With Lock in, LCD lay back 0˚ ~ 15˚ (positive and negative 2˚) With Lock off , LCD can lay back up to 90˚ for hanging Hanging Unlock Lay back the stand Use the tape measure to determine the position of two holes and mark them down. (112mm of the total length from eight edges) Pick the right drill to bore holes in the wall.
Monitor Adjusting Menu control button There 5 keys for user to set up the monitor, including, “OSD menu “, “Auto Tune”, ”Increase<+>”,”Decrease<->”, “Power”. The following descriptions are the introduction of these Keys. Key Introduction “Power”: Turn the LCD power on and off. When the power is on, the light is showing green, standby will be orange.
Cleaning Notice Be gentle to clean the screen. Never, ever, using any kind of corrosiveness chemical dissolvent to clean the screen, it may hurt your screen surface. We suggest that using a clean camel hair brush or a soft, clean, lint-free cloth to wipe the screen.
OSD (On-Screen Display) Menu Mode Option select 1. Press the OSD button to access menu. 2. Using Auto Tune for left adjustment. 3. Press OSD again for right adjustment. Brightness: Adjust the brightness of the display. Main menu brightness adjust Phase:...
Page 11
EXIT : Saving and Leave. Main menu EXIT adjust Return : Return to main menu. Vertical Position: Adjust the vertical position of the OSD. OSD V position adjust Auto color: Adjust the color automatically. Auto color adjust Miscellaneous Horizontal Position: Adjust the horizontal position of the...
DISPLAY MODE Resolution 640X350 640X480 640X480 720X400 800X600 800X600 1024X768 1024X768 We offer you 8 available modes compatible with Windows. If any interference occurs on your screen while you modulating your PC or OSD. It is normal. To have Best quality present on the PC, remember to upgrade your video card Driver. We strongly recommend you to choose a Mode listed in the table.