SOYO SY-5SSM Quick Start Manual page 14

SY-5SSM & SY-5SSM/5 Quick Start Guide
Enable/Disable the Onboard Sound (JP9)
Step 7.
The onboard audio features of your Motherboard are controlled by jumpers JP9
Choose the available sound options among the following table:
Sound Settings
Onboard Sound: Enable
Onboard Sound: Disable
Clear CMOS Data (JP5)
In some cases the CMOS memory may contain wrong data, follow the steps below to
clear CMOS memory.
1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. This
jumper can be easily identified by its white colored cap.
2. Then put the jumper back to 1-2 to allow writing new of data into the CMOS
memory.
CMOS Clearing
Short pin 2-3 for a
JP5 Setting few seconds to
clear the CMOS
Note: You must unplug the ATX power cable from the ATX power connector when
performing the CMOS Clear operation.
Clear CMOS Data
1 2 3
12
JP9
short
open
Retain CMOS Data
Short pin 1-2
to retain new
settings 1 2 3