GENERAL SAFETY INSTRUCTIONS FOR KARNASCH MAGNETIC HOLE CUTTING MACHINES
OPERATING INSTRUCTIONS FOR
KATV55 / KATSV55 / KATV100
KATSV100 / KATV140
SWITCH PANEL
SPEED
CONTROL
ON SWITCH
PANEL
Motor gear selector on
Down
left side of gear box.
for low gear
Check if work surface
is clean.
NOTE:
Electronic torque
control is fitted on
motor side above
switch panel
For more information please call +49 6203-4039-0 or send a mail to mail@karnasch.tools.
Up
for high gear
TAPPING
1
2
3
Fig 1
•
Fit tapping arbor with
suitable collet and tap
into 2/3 MT socket on
machine.
•
Position machine switch
on magnet.
•
Select required speed/
gear/and torque.
•
Select forward on for
ward/reverse switch.
•
Switch. Press start but-
ton. Turn handles to
lower tap into pre-drilled
holes gently.
Fig 2
•
Tap will start to cut and
screw itself into the hole.
•
No pressure is required
from the operator.
•
When
tap
reaches
required depth, switch
machine to reverse.
•
Machine will stop auto-
matically.
Fig 3
•
Press
restart
button,
machine will start in
reverse after a short time
and will screw the tap out.
•
When completely out, stop
machine and select for-
ward.
•
Ready for next operation.