Electrical Installation - American Standard Paradigm Selectronic 7025.1 Series Installation Instructions Manual

ELECTRICAL INSTALLATION

Product
PWRX Power Kit
(PK00.WRK)
Plug-In AC Power Kit (PK00.PAC)
Hard-Wired AC Power Kit (PK00.HAC)
Multi-AC Power Kit (PK00.MAC)
Important: All faucets with the standard CR-P2 battery
come preaseambled from the factory. No further action
necessary.
PWRX 10 YEAR BATTERY
A
SYSTEM; Fig. 1
PWRK VERSION;
™
1. Connect PWRX BATTERY PACK (1) to SENSOR
CABLE (2).
2. Secure the connections by installing into CONNECTOR
LOCKING DEVICE (3) as shown. Rotate the END CAPS
(4) to secure the connection within the CONNECTOR
LOCKING DEVICE (3).
3. Determine the mounting location of the PWRX BATTERY
PACK (1) by marking center lines as shown.
4. Place the BRACKET (5) on the horizontal center line
and mark the location of the mounting holes to be drilled.
5. Using 1/4" diameter drill bit, drill two mounting holes
aproximately 1" deep.
6. Install the two ANCHORS (6) provided into the mounting
holes.
7. Place the BRACKET (5) over the ANCHORS (6)
and secure with the SCREWS (7) provided.
Do not overtighten.
8. Insert PWRX BATTERY PACK (1) into BRACKET (5).
Fig. 1
Page
4
5
5
5
BRACKET INSTALLATION
VERTICAL
C/L
4
2
1
1
HORIZONTAL
C/L
4
3
4
3
6
5
7
M965985 (11/18)